Minolta Di620PE Operato's Manual page 36

3-10
3. Selecting the Finishing
Folding
<Only with the Finisher FN-3>
<Crease>
Crease makes a crease in the print at its center
before it is fed out.
Sizes of paper that can be loaded:
NOTE
Even if Staple is previously set to a corner or side position, the setting of Crease automatically cancels
this setting and reselects a center stapling position.
<Half-Fold>
Half-Fold folds the print in two at its center with
the print surface on the outside.
ex.) A3→A4,
"× "
11 17
Sizes of paper that can be loaded: 11"×17"L, A3L,
B4L
* The finished print size has a length half that of
the paper loaded in the printer.
NOTE
Even if Staple is previously set to a corner or center position, the setting of Half-Fold automatically
cancels this setting and reselects a side stapling position.
Di620PE Operator's Manual
1155O039AA
1155O041AA
→ Letter
A3L, B4L, A4L, 11"×17"L, LetterL
Make sure to select the correct stapling function
when making prints with the Crease function if
you want to make a stapled print set.
You can produce a document that looks like below
by combining this function with Staple and Hole
Punch.
Number of sheets: 2~10
1155O640EA