Minolta Di620PE Operato's Manual page 32

3-6
3. Selecting the Finishing
Hole Punch
Select the desired finishing function.
1
Refer to the printer driver manual
(PrintStation Manager Reference Manual)
for a detailed description of the setting
procedures and setting items.
NOTES
• The size of the paper for Hole Punch is
11"×17"L, LegalL, LetterL, LetterC, A3L,
A4L and A4C only.
• Hole Punch is not possible in the Interrupt
mode.
• When making prints in the Hole Punch Mode,
make sure of the correct document
orientation.
<Only when the Finisher FN-3 is mounted>
• The number of punch holes can be changed
between "2-Hole" and "3-Hole" by using the
Knob located inside the Finisher.
* When changing the setting for the number of
holes to be made, be sure the
aligned.
Pull out Knob: 2-Hole
Push in Knob: 3-Hole
* The number of punch holes can be graphically
identified on the Display.
Di620PE Operator's Manual
Useful Tips
• If you do not select a hole-punching position,
the printer automatically sets the Hole Punch
position according to the document
orientation illustrated below.
• When making prints from either the 11"×17"
or LegalL, A3L or B4L size, the printer
marks are
automatically specifies the hole punching
position as shown below.
Knob
1155O723AA
On Screen Print
1155O789EA
On Screen
Print
1155O790EA
On Screen
Print
1155O791EA