Seat Belt; Fastening The Seatbelt With Buckle; Adjustment Of Belt Length - Meyra Polaro II 1.745 Operating Manual

SEAT BELT

The seatbelt serves to strap in a per-
son sitting in the wheelchair.
– Additional stabilisation of the sit-
ting position.
– Prevents the user from falling for-
wards out of the wheelchair.
– Continuous adjustment to suit the
user's needs.
The seatbelt is screwed from the back
onto the respective back support
tube.
☞
Note:
The retrospective assembly of a re-
taining strap is only to be carried
out by a specialist workshop!
Attention:
!
The retaining strap is not part of
the retaining system for the wheel-
chair and/or user during transport
in a handicapped vehicle.
Fastening the seatbelt with buck-
le
–
Pull both belt halves to the front
and slide the catch halves together
so that they latch together. Then
carry out a pull test.
To open the seatbelt the red locking
button (1) is pressed down.
Attention:
!
Make sure that no objects are
trapped between belt and the
body! – Thus you avoid painful
pressure points
1

Adjustment of belt length

☞
Note:
The seatbelt should not be pulled
too tight.
The length of the seatbelt can be
changed by sliding the buckle (2) and
/ or pulling the end of the strap (3).
2
3
47