Table of Contents
Advertisement
WHEELS
Drive wheels
The drive wheels are on a quick re-
lease axle.
Quick release axle
The driving wheels can be removed
and reassembled without any tools.
– For this fi rst unlock the quick re-
lease axle by pressing the spring
button (1), then pull the drive
wheel off toward the outside.
To replace the drive wheels unlock the
respective quick release axle by press-
ing the spring button (1) and press it
as far as possible into the axle recep-
tacle.
Attention:
After each assembly the locking
!
device is to be checked with side-
ward pulling/pressing on the drive
wheels (fi g. 38).
•
The quick release axle is to be kept
clean. A functional fault may occur
in the case of contamination due
to sand or earth or in the event of
freezing of moist cold air.
•
If the drive wheels has too much
sideward lag or the axle does not
engage, have it maintained imme-
diately by the specialist dealer.
42
1
☞
Note:
The air pressure of the tyres is not-
ed on both sides of the wheels or
can be viewed in the < Technical
data >.
Advertisement
Table of Contents
