Adjusting The Brakes; Fine Adjustment Of The Pressure Brakes - Meyra Polaro II 1.745 Operating Manual

Adjusting the brakes

According to the < Maintenance in-
structions > the brakes are to be
checked for function after each repo-
sitioning of the drive wheels and re-
adjusted if necessary.
– Loosen the clamping screws (1) of
one pressure brake.
– Afterwards pre-adjust the respec-
tive brake by repositioning it ac-
cordingly.
Pressure brake:
– For this slide the brake bolt of the
inactivated brake to approx. 5 mm
- 10 mm in front of the drive wheel
and align it at a right angle to the
drive wheel.
– Retighten the clamping screws (1).
Adjust opposite pressure brakes as de-
scribed.
Equally adjust both pressure brakes,
taking into account
– tread of the drive wheels,
– air pressure of the tyres and
– user weight.
adjust evenly. – Danger of accidents
caused by one sided braking effect!
1
Fine adjustment of the pressure
brakes
– Slacken the clamping screws (1).
– Fine tuning is achieved by slight re-
positioning of the respective pres-
sure brake.
– Retighten the clamping screws (1).
☞
Note:
Inspect function and accurate fi t of
the pressure brakes (2).
2
51