The Wps Station Screen - ZyXEL Communications P-2812HNU-51c User Manual

7.7 The WPS Station Screen

Use this screen to set up a WPS wireless network using either Push Button
Configuration (PBC) or PIN Configuration.
Note: If you select No Security in the Wireless LAN > General screen and click
Push Button in the WPS Station screen, the P-2812HNU-51c automatically
changes to use WPA-PSK/WPA2-PSK mixed mode and generates a pre-
shared key.
Click Network > Wireless LAN > WPS Station. The following screen displays.
Figure 61 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 37 Network > Wireless LAN > WPS Station
LABEL
Push Button
Or input
station's PIN
number
P-2812HNU-51c User's Guide
DESCRIPTION
Click this button to add another WPS-enabled wireless device (within
wireless range of the P-2812HNU-51c) to your wireless network. This
button may either be a physical button on the outside of device, or a
menu button similar to the Push Button on this screen.
Note: You must press the other wireless device's WPS button within
two minutes of pressing this button.
Enter the PIN of the device that you are setting up a WPS connection
with and click Start to authenticate and add the wireless device to your
wireless network.
You can find the PIN either on the outside of the device, or by checking
the device's settings.
Note: You must also activate WPS on that device within two minutes
to have it present its PIN to the P-2812HNU-51c.
Chapter 7 Wireless LAN
143