Wpa(2)-Psk - ZyXEL Communications P-2812HNU-51c User Manual

Table 30 Network > Wireless LAN > General: Static WEP Encryption
LABEL
WEP
Encryption
Key 1 to Key
4

7.4.3 WPA(2)-PSK

In order to configure and enable WPA(2)-PSK authentication; click Network >
Wireless LAN to display the General screen. Select WPA-PSK or WPA2-PSK
from the Security Mode list.
Figure 54 Wireless LAN > General: WPA(2)-PSK
P-2812HNU-51c User's Guide
DESCRIPTION
WEP (Wired Equivalent Privacy) provides data encryption to prevent
unauthorized wireless stations from accessing data transmitted over the
wireless network.
Select 64-bit or 128-bit to enable data encryption.
The WEP key is used to secure your data from eavesdropping by
unauthorized wireless users. Both the P-2812HNU-51c and the wireless
stations must use the same WEP key for data transmission.
Only one key can be activated at any one time. Select a default key to use
for data encryption.
If you chose 64-bit in the WEP Encryption field, then enter any 5
characters (ASCII string) or 10 hexadecimal characters ("0-9", "A-F")
preceded by 0x for each key.
If you chose 128-bit in the WEP Encryption field, then enter 13
characters (ASCII string) or 26 hexadecimal characters ("0-9", "A-F")
preceded by 0x for each key.
Chapter 7 Wireless LAN
135