Thermador PRD30 Installation Manual page 8

Installation with Low Back or High Shelf
Combustible
_27 %" (702mm)
4_27 1/4"(692mm)
36" (914mm)
min. to_
combustibles
ax 36 ¾"
(933mm)
Min 35 _"
(il 1mm)
Materials
10¾"
(273mm',
I--
High Shelf-__-2il__.__ _'
÷
36" & 48" Low Back
30" Low Back Guard
24 %"
(625mm)
24" max.
(606mm)
Front Face
24 ¾"
(629mm)
1'
22"
(559mm)
Back Wall
.41 23" _-
• (584mm) •
as defined in the "National Fuel Gas
"_ode" (ANSI Z223.1, Current Edition).
"_learances from non-combustible materials
_re not part of the ANSI Z21.1 scope and are
_ot certified by CSA. Clearances of less than
12" (305 mm) must be approved by the local
;odes and/or by the local authority having
urisdiction.
Installation with Flush Island Trim
36" (914 mm)
min. to
combustibles
1
Note: For Flush Island
Trim installations,
counter surface should
have a cantilever edge
meeting the back sectior
of the Flush Island Trim
accessory.
I
I
I
Flush Island Trim I
13/16" ( 21mm) ha _tht I
12" (305mm) min
to combustible_
surface with Flush
Island Trim
Materials_
Note:
With the oven door fully open, the top of the
door extends to 44 %" (1140mm) from the
back wall, behind the range when installed.
Installation must allow ample clearance for
movement around the door when fully
opened.
t
Max 36
(933mm)
Min 35 _"
(911mm)
Front Face
Cantilever
If an inner wall is
used under the cantilever
counter top, there should
be a _,/_" ( 3mm) gap from
the rear of the range to the
inner wall.
Figure 2: Side View
English 6