Thermador PRD30 Installation Manual page 19

Step 7: Backguard Installation (optional)
30" Included with Range N/A PA30GHSH PA30GITH
36" N/A PA36GLBH PA36GHSH Included with range
48" N/A PA48GLBH PA48GHSH Included with range
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Backsplash Installation
(PA [30,36, 48] JBS)
10 - 1" (25.4mm) Phillips screwdriver or
screws drill
_'_-_-1 1 - Backsplash Tape measure
1 - Installation Guide Pencil
The backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the backsplash.
To protect against scratches, leave protective film on
backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies.
Move range forward to gain access to rear of unit.
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
1. Locate and lightly mark wall studs.
• Wall studs are usually installed with a 16" or 24"
(406mm or 1372mm) space on center.
2. The height of the hood will determine the height of the
top edge of the backsplash. The backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the backsplash 1½" (38mm).
3. Per each wall stud, use (2) of the provided screws to
secure both the top and bottom of the backsplash (see
Figure 15).
• Due to variable wall stud widths and varying
backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4. Remove protective plastic.
30", 36", 48"
(760mm, 913mm, 1218mm)
I "T'° ....
!;o;
iI i
l= i
iI i
l= i
II I
A I I I
E ;, ,
I I I
/E /,',
I_ /1,', 1,
1 l"
ii I
iolo °
Wall Stud
i_ j II m
I_ I II I
II I II J
I_ I II I
I_ I II J
It I II l
I_ I II I
II I II I
li I II I
I_ I II J
I_ I II J
I_ I II t
I_ I II t
I_ I II l
I_ I II l
It I II I
li J II _
I_ J II l
Space screws evenly
across top & bottom
Figure 15: Backsplash Installation
English 17