Thermador PRD30 Installation Manual page 25

To Reinstall the Oven Door:
1. Position the door at a sharp angle (see Figure 23) and
insert the hinges centered evenly into the hinge slots.
The hinges will securely hook into the slots when
properly installed. Do not force, bend, or twist the door.
• TIP: Rest the door on your foot while using your leg
for stability.
2. Open the door fully and use a screwdriver to push the
hinge clips all the way into the hinge slots (toward the
oven) until they meet the hinge. Be careful not to
scratch the range during this process.
Turn this
screw to
adjust door
alignment.
,
Figure 24: Hinge Receiver Adjustment Screw
The range must be level for proper alignment of the
oven doors, see "Step 9: Placing and Leveling the
Range" on page 24.
Figure 23: Approximate Door Angle for Removal
To Check Door Fit and Operation:
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
3. For 48" models with large and small ovens, if door or
handle appears slightly tilted, you may adjust the hinge
receiver by rotating the large Torx-head screw located
directly above the hinge receiver with a T-20 Torx
driver. Rotate each screw respective to its side and
direction the door needs to be adjusted (Figure 24).
Data Rating Label Location
Data rating labels contain the model and serial numbers
that can be found under front edge of the rangetop, with
oven door open or removed.
Data
Rating
Label
x
Figure 25: Data Rating Label Location
English 23