Thermador PRD30 Installation Manual page 10

NOTICE:
-- If not already present, install gas shut-off valve in
an easily accessible location.
-- Make sure all users know where and how to shut
off the gas supply to the range.
-- Any opening in the wall behind the appliance and
any opening in the floor under the appliance must
be sealed.
The dual fuel ranges may be connected to the power
supply with a range supply cord kit or by hard-wiring to the
power supply. It is the responsibility of the installer to
provide the proper wiring components (cord or conduit and
wires) and complete the electrical connection as dictated
by local codes and ordinances, and/or the National Electric
Code. The units must be properly grounded. Refer to see
"Step 6: Electrical Requirements, Connection & Grounding"
on page 14 for details. Canadian models have power cord
supplied.
The range must be connected only to the type of gas
for which it is certified. If the range is to be connected to
propane gas, ensure that the propane gas supply tank is
equipped with its own high pressure regulator in addition to
the pressure regulator supplied with the range (see "Step 5:
Gas Requirements and Hookup" on page 13).
NOTE:
The range is designed for flush installation to the back wall.
For a successful installation, it may be necessary to
reposition the gas-supply line and electrical cord as the
range is pushed back to its final position.
-- SUGGESTION: This may be accomplished by carefully
pulling on a rope or twine looped around the gas or
electrical supply line as the range is pushed back into
its final installed position.
Electrical Supply
Installation of the range must be planned so that rough-in
of terminal block for the receptacle or conduit connection
will allow maximum clearance to the rear of the unit.
When the power supply cord or conduit is connected to the
mating receptacle or terminal block cover, the combined
plug/receptacle or terminal block cover/conduit connector
should protrude no more than 2" (51 mm) from the rear wall.
See Figure 3b.
Refer to Figure 11 on page 15for location of terminal block
on unit. To minimize binding when the unit is connected to
the receptacle or terminal block, orient the receptacle or
conduit connector, and slide back into position.
NOTE:
Canadian models have power cord supplied with range.
NOTE:
When using a 240VAC receptacle having its own housing,
it will be necessary to recess the receptacle's housing into
the rear wall. Mount the receptacle securely to a wall stud,
then seal around the receptacle's housing. Follow all local
electrical codes.
2" (51 mm) maximum
when plugged in
I
Power Cord
& Receptacle
2" (51 mm)
maximum
I
I
I
I
I
Junction Box
& Conduit
Figure 3b: Wall Connection
English 8