Irf Stack Configuration Example - 3Com Baseline 2928 PWR Plus User Manual

Figure 1-5 Device summary (a slave device)
Return to Stack configuration task

IRF Stack Configuration Example

Network requirements
As shown in
another.
Create a stack, where Switch A is the master device, Switch B, Switch C, and Switch D are slave
devices. An administrator can log in to Switch B, Switch C and Switch D through Switch A to
perform remote configurations.
Figure 1-6 Network diagram for IRF stack
Stack
GE1/0/1
SwitchC: Slave device
Configuration procedure
1) Configure the master device
# Configure global parameters for the stack on Switch A.
Select IRF from the navigation tree of Switch A to enter the page of the Setup tab, and then
perform the following configurations, as shown in
list.
Figure 1-6, Switch A, Switch B, Switch C, and Switch D are connected with one
SwitchA: Master device
GE1/0/1
GE1/0/2
GE1/0/3
GE1/0/1
SwitchB: Slave device
GE1/0/1
SwitchD: Slave device
Figure 1-7.
1-6