Configuring Your Printer Using Epsonnet Winassist - Epson AcuLaser C8600 Administrator's Manual

Configuring Your Printer Using EpsonNet
WinAssist
This section explains how to use EpsonNet WinAssist to set an IP
address for the Internal Print Server.
Note:
If you are using the printer in a dial-up environment not running
NetWare, clear the use NetWare check box on the NetWare screen.
If this check box is selected, the extra account may be charged when
you use the dial-up router.
When configuring the Internal Print Server for NetWare, use the
IPX protocol and log in to the NetWare server or the NDS context
with supervisor privileges.
When you configure the Internal Print Server for NetWare 5.x, you
must log in to the NetWare server using an IPX connection. If you
log in to the NetWare server using an IP connection, the NetWare
screen and the IPX trap setting of SNMP are not available.
To set the IP address for OS/2 and UNIX, use the arp and ping
commands. For more information, see "Setting an IP Address Using
the arp/ping Command" on page 234.
Follow the steps below to set the IP address. The sample screens
are taken from Windows 95 using EpsonNet WinAssist. Other
systems differ in appearance, but the instructions are the same,
except as noted.
1. Check that the necessary protocols are installed on the
computer.
2. Turn on your printer.
3. Start EpsonNet WinAssist.
EpsonNet WinAssist Configuration Utility
4
4
4
4
4
4
4
4
4
4
4
4
43