Appendix A
Tips for Administrators
Instructions on Using a Dial-Up Router
This section describes instructions on using a dial-up router.
If DHCP is used to assign an IP address to the printer, you need
to change the printer port setting every time you turn on the
printer. Therefore, we recommend that you set a valid IP address
for the Internal Print Server by using the one of the following
methods.
Set the IP address for the Internal Print Server manually. Use
EpsonNet WinAssist or MacAssist. See "Configuring Your
Printer Using EpsonNet WinAssist" on page 43 or
"Configuring Your Printer Using EpsonNet MacAssist" on
page 70.
Specify the Internal Print Server by using the bind of DHCP
function.
Set the exclusive address of the DHCP function.
Note:
Use NetBEUI printing if you do not want to go through these steps.
See the manual of the Dial-Up router for more information on scorp
range, bind, exclusive address of the DHCP function.
Tips for Administrators
A
A
A
A
A
A
A
A
A
A
A
A
223