Setting And Checking The New Ip Address - Epson AcuLaser C8600 Administrator's Manual

If you press Ctrl-C, you may see something like this:
192:168:192:168 PING Statistics
3 packets transmitted, 0 packets received,
100% packet loss
Again, the exact wording of the message you see may differ
from this, depending on your operating system. If you cannot
"ping" the Internal Print Server, check the following:
The address in the ping command is correct.
The Ethernet connection to the Internal Print Server and
to the host has been made correctly, and all hubs, routers,
etc. are switched on.
The Internal Print Server is operating normally (red light
off, green or orange light on).

Setting and checking the new IP address

To set the new IP address which you have obtained from your
system administrator, use the arp command with the -s flag
(create an ARP entry).
Note:
In the following procedure, we assume that the MAC address of your
Internal Print Server is 00:00:48:93:00:00 (hexadecimal), and that the
IP address which you will be assigning is 192.168.100.201 (decimal).
Substitute your values for these addresses when you type in the
commands.
1. From the command line, type:
Example: arp -s 192.168.100.201 00-00-48-93-00-00
2. You can now check the new IP address, by "pinging" it:
Example: ping 192.168.100.201
236 Setting an IP Address for the Printer