Using Bindery Print Server (Netware 3.X/4.X) - Epson AcuLaser C8600 Administrator's Manual

Time required to recognize the Internal Print Server
It takes up to two minutes for the NetWare server to recognize
the Internal Print Server, after the printer is turned on. During
this start-up time, the status sheet does not show the correct
information.
Frame type
The same frame type should be used for the NetWare server
and IPX router on the same network. If more than one frame
type is used on the same network, bind all the frame types to
the NetWare servers and IPX routers.
For NetWare 5.x
The IPX protocol must be installed (bound) on the
NetWare 5.x server.
About modes
If the mode you have logged in is different from the mode you
set for the Internal Print Server, a message appears when you
try to configure the Internal Print Server for NetWare. If you
do not want to change the current settings, click Cancel and
log in again using the same mode set for the Internal Print
Server.

Using Bindery Print Server (NetWare 3.x/4.x)

This section contains instructions on using the Internal Print
Server in the Print Server mode on NetWare
3.x/4.x/IntranetWare with Bindery emulation.
Note:
The Internal Print Server in the Print Server mode of NetWare 3.x does
not allow you to use the Print Server status display control with
PCONSOLE.
108 Settings for NetWare Server