Disabling The Standby Mode - Epson AcuLaser C8600 Administrator's Manual

Disabling the Standby Mode

If the printer receives no data for 30 minutes, it enters the Standby
mode. In this mode, the printer begins warming up as soon as you
send a print job; it then warms up and is ready to print in about
65 seconds at rated voltage.
To disable the Standby mode, follow the instructions below.
1. Make sure the printer is turned off.
2. Hold down the Down button while you turn on the printer.
3. When you see the message Support Mode on the LCD panel,
select Standby in the support menu.
4. Use the Up or Down button to select Standby = Disable .
5. Press the Enter button.
6. To exit the SelecType mode, press the Start/Stop button.
222 Troubleshooting