Half-Fold Position; Tri-Fold Position Adjustment - Oce VarioLink 4522c User Manual

7.1 System Settings

Half-Fold Position

Adjust the center staple & fold and half-fold positions.
0 Before making any adjustments, create a sample using the half-fold function. Adjust the half-fold
position while checking the created sample.
0 It can be adjusted only when the saddle sticher is installed.
0 When adjusting the half-fold position in parallel with the left edge of paper, contact your service
representative.
1
Press the [Utility/Counter] key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Half-Fold Position].
2
Select the size of paper of which half-fold position is adjusted.
3
Press [+] or [-] to adjust the punched hole position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.

Tri-Fold Position Adjustment

Adjust the folding position for each paper size when printing with the tri-fold function. The folding width
depends on the paper size, which cannot be changed.
0 Before making any adjustments, create a sample using the tri-fold function. Adjust the tri-fold position
while checking the created sample.
0 It can be adjusted when the Finisher FS-526 and Saddle Stitcher SD-508 are installed.
1
Press the [Utility/Counter] key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Tri-Fold Position Adjustment].
2
Select the size of paper of which tri-fold position is adjusted.
3
Press [+] or [-] to adjust the tri-fold position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.
VL6522c/VL5522c/VL4522c
7
7-17