1.7
RESETTING THE CGN2
When you reset the CGN2 to its factory defaults, all user-configured settings are lost,
and the CGN2 is returned to its initial configuration state.
There are two ways to reset the CGN2:
Press the RESET button on the CGN2, and hold it in for ten seconds or longer.
Click WAN/LAN > Backup. In the screen that displays, click the Factory Reset
button.
The CGN2 turns off and on again, using its factory default settings.
NOTE:
Depending on your CGN2's previous configuration, you may need to re-
configure your computer's IP settings; see IP Address Setup on page 21.
25
25
HITRON CGN2 USER'S GUIDE
Version 2.0, February 2012. Copyright
Version 2.0, February 2012. Copyright
2012 Hitron Technologies
2012 Hitron Technologies