Hitron CGN2 User Manual page 49

Table 12: The WAN/LAN > IP Screen (continued)
Assign DNS
Manually
DNS Server
Private LAN IP Setting
IP Address
Subnet Mask
Domain Suffix
Private LAN DHCP Setting
Enable LAN DHCP
Lease Time
DHCP Start IP
49 49
HITRON CGN2 USER'S GUIDE
Select the checkbox to enable manual DNS server

assignment, and enter the DNS servers that you want
to use in the DNS Server fields below.
Deslect the checkbox to disable manual DNS server

assignment. The CGN2 uses the DNS servers
assigned automatically when it receives an IP address
over the WAN.
It is strongly recommended that you do not enable manual
DNS server assignment unless you have good reason to
do so.
These fields display the Domain Name Servers that the
CGN2 uses to resolve domain names into IP addresses.
If you selected the Assign DNS Manually checkbox,
enter the DNS servers that you want to use in these fields.
Use this field to define the IP address of the CGN2 on the
LAN.
Use this field to define the LAN subnet. Use dotted
decimal notation (for example, 255.255.255.0).
Use this field to define the domain that you can enter into a
Web browser (instead of an IP address) to reach the
CGN2 on the LAN.
It is suggested that you make a note of your device's
Domain Suffix in case you ever need to access the
CGN2's GUI without knowledge of its IP address.
Select this if you want the CGN2 to provide IP addresses
to network devices on the LAN automatically.
Deselect this if you already have a DHCP server on your
LAN, or if you wish to assign IP addresses to your
computers and other network devices manually.
Use this field to define the time after which the CGN2
renews the IP addresses of all the network devices
connected to the CGN2 on the LAN (when DHCP is
enabled).
Use this field to specify the IP address at which the CGN2
begins assigning IP addresses to devices on the LAN
(when DHCP is enabled).
Version 2.0, February 2012. Copyright
Version 2.0, February 2012. Copyright
2012 Hitron Technologies
2012 Hitron Technologies