Hitron CGNVM Series Quick Start Manual

QUICK START GUIDE
HITRON
CGNVM
Connect to the network
Connect to the telephone
Set up your wireless network
Connect to a Cable Outlet
STEP
Use a coaxial cable (not included) to connect the device's CABLE
2
connector to a cable outlet.
Connect to a Telephone Device (Optional)
STEP
Use a telephone cable (not included) to connect one of the LINE
4
ports to a telephone device. Do this only if you have ordered
telephone service.
User Configuration (Optional)
STEP
In a web browser, enter 192.168.0.1 in the address bar followed by
6
Username and Password, as below.
Check the Box Contents
STEP
1
Read me
first!
The Hitron CGNVM is an application gateway that provides wired and
wireless high-speed Internet access as well as MoCA (Multimedia over Coax
Alliance) networking to the Ethernet-enabled devices in your home for a
fast and easy home entertainment network.
Connect to a Power Outlet
STEP
3
Connect to an Ethernet-Equipped Device (Optional)
STEP
5
Connect with Wireless Devices (Optional)
STEP
7
Connect your wireless devices with the WiFi
Protected Setup (WPS). Access the configuration
interface (see step 6), enter the Wireless page
cusadmin
to enable WPS and set Encrypt Mode to AES,
then press Save Changes.
password
Press this button to begin the WPS Push-Button
Configuration (PBC) procedure. Press the PBC
button on your wireless clients in the coverage
area within two minutes to enable them to join
the wireless network.
Look in the box and make sure you have the following:
HITRON CGNV HITRON CGNVM POWER CORD
Use the power cord provided to connect the POWER port to a power
outlet.
Use the Ethernet cable provided to connect one of the LAN ports
to an Ethernet-equipped device.
Connect your wireless devices with the correct SSID and Passphrase.
If you have not changed them, the default values are indicated on
the sticker on the back of the unit.
ETHERNET CABLE QUICK START GUIDE