The Shared Media Screen - Hitron CGN2 User Manual

Table 12: The WAN/LAN > IP Screen (continued)
DHCP End IP
Connected Computers
Host Name
IP Address
MAC Address
Type
Interface
Apply
Cancel
Help
3.3

THE SHARED MEDIA SCREEN

Use this screen to manage and share data stored on devices connected to the
CGN2's USB port. The CGN2 provides one USB 2.0 host port, allowing you to plug in
a USB flash disk for mounting and sharing through the LAN interfaces via the Samba
protocol (network neighborhood).
NOTE: This screen is not available unless a logged-in MSO admin user previously
enabled the USB option in the Status > Capability screen; see The
Capability Screen on page 42 for more information.
Click WAN/LAN > Shared Media. The following screen displays.
50 50
HITRON CGN2 USER'S GUIDE
Use this field to specify the IP address at which the CGN2
stops assigning IP addresses to devices on the LAN
(when DHCP is enabled).
NOTE: Devices requesting IP addresses once the DHCP
pool is exhausted are not assigned an IP address.
This displays the name of each network device connected
on the LAN.
This displays the IP address of each network device
connected on the LAN.
This displays the Media Access Control (MAC) address of
each network device connected on the LAN.
This displays whether the device's IP address was
assigned by DHCP (DHCP-IP), or self-assigned.
This displays whether the device is connected on the LAN
(Ethernet) or the WLAN (Wireless(x), where x denotes
the wireless mode; b, g or n).
Click this to save your changes to the fields in this screen.
Click this to return the fields in this screen to their last-
saved values without saving your changes.
Click this to see information about the fields in this screen.
Version 2.0, February 2012. Copyright
Version 2.0, February 2012. Copyright
2012 Hitron Technologies
2012 Hitron Technologies