Troubleshooting And Maintenance - Weider 900 User Manual

TROUBLESHOOTING AND MAINTENANCE

TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened.
Slack can be removed by moving a 90mm Pulley
(34), a Cable Trap (36), and two Finger Guards (35)
to a set of holes closer to the center of the two Pulley
Plates (44). Remove the M10 Nylon Locknut (68) and
the M10 x 52mm Bolt (52), and reattach the Pulley,
Cable Trap, and Finger Guards to the different set of
holes in the Pulley Plates.
Slack can also be removed by moving the 90mm
Pulley (34), the Cable Trap (36), and the two Finger
Guards (35) to the higher set of holes in the "U"-brack-
et (43). Remove the M10 Nylon Locknut (68) and the
M10 x 52mm Bolt (52), and reattach the Pulley, the
Cable Trap, and two Finger Guards to the higher set
of holes in the "U"-bracket.
Finally, slack can be removed from the cables by tight-
ening the M8 Nylon Locknut (69) attaching the Short
Cable (47) to the "U"-bracket (43). The High Cable (not
shown) and the Small "U"-bracket (not shown) can be
adjusted in the same manner.
Make sure that the cables are not too tight, or the
Top Weight (not shown) will be lifted off the weight
stack.
52
35
36
52
35
19
44
35
68
34
47
43
71
69
68
36
34
35