NETGEAR GS716T Software Administration Manual page 38

2. Use the menu to select the Coordinated Universal Time (UTC) time zone in which the switch
is located, expressed as the number of hours.
3. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
4. Use the SNTP Server Configuration page to configure the SNTP server settings, as
described in SNTP Server Configuration
5. Click Refresh to refresh the page with the most current data from the switch.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
The SNTP Global Status table on the Time Configuration page displays information about
the system's SNTP client. The following table describes the SNTP Global Status fields.
Field
Version
Supported Mode
Last Update Time
Last Attempt Time
Last Attempt Status
Server IP Address
Address Type
Server Stratum
38 | Chapter 2: Configuring System Information
GS716Tv2 and GS724Tv3 Software Administration Manual
on page 39.
Description
Specifies the SNTP Version the client supports.
Specifies the SNTP modes the client supports. Multiple modes may be
supported by a client.
Specifies the local date and time (UTC) the SNTP client last updated the
system clock.
Specifies the local date and time (UTC) of the last SNTP request or receipt
of an unsolicited message.
Specifies the status of the last SNTP request or unsolicited message for both
unicast mode. If no message has been received from a server, a status of
Other is displayed. These values are appropriate for all operational modes:
•
Other: None of the following enumeration values.
•
Success: The SNTP operation was successful and the system time was
updated.
•
Request Timed Out: A directed SNTP request timed out without
receiving a response from the SNTP server.
•
Bad Date Encoded: The time provided by the SNTP server is not valid.
•
Version Not Supported: The SNTP version supported by the server is
not compatible with the version supported by the client.
•
Server Unsynchronized: The SNTP server is not synchronized with its
peers. This is indicated via the 'leap indicator' field on the SNTP
message.
•
Server Kiss Of Death: The SNTP server indicated that no further
queries were to be sent to this server. This is indicated by a stratum field
equal to 0 in a message received from a server.
Specifies the IP address of the server for the last received valid packet. If no
message has been received from any server, an empty string is shown.
Specifies the address type of the SNTP Server address for the last received
valid packet.
Specifies the claimed stratum of the server for the last received valid packet.