NETGEAR GS716T Software Administration Manual page 262

3. In the Guest VLAN field for ports e1–e8, enter 150 to assign these ports to the guest VLAN.
You can configure additional settings to control access to the network through the ports.
See Port Security Interface Configuration
4. Click Apply.
5. From the 802.1X Configuration screen, set the Port Based Authentication State and Guest
VLAN Mode to Enable, and then click Apply (See
page 178).
This example uses the default values for the port authentication settings, but there are
several additional settings that you can configure. For example, the EAPOL Flood Mode
field allows you to enable the forwarding of EAPoL frames when 802.1X is disabled on
the device.
6. From the RADIUS Server Configuration screen, configure a RADIUS server with the
following settings:
• Server Address: 192.168.10.23
• Secret Configured: Yes
• Secret: secret123
• Active: Primary
For more information, see
7. Click Add.
8. From the Authentication List screen, configure the default List to use RADIUS as the first
authentication method (See
This example enables 802.1X-based port security on the GS716T or GS724T switch and
prompts the hosts connected on ports e1–e8 for an 802.1X-based authentication. The switch
passes the authentication information to the configured RADIUS server.
262 | Appendix B: Configuration Examples
GS716Tv2 and GS724Tv3 Software Administration Manual
on page 179 for information about the settings.
RADIUS Configuration
Authentication List Configuration
Port Security Configuration
on page 151.
on page 159).
on