NETGEAR GS716T Software Administration Manual page 17

GS716Tv2 and GS724Tv3 Software Administration Manual
To modify the network settings on your administrative system:
1. On your PC, access the MS Windows operating system TCP/IP Properties.
2. Set the IP address of the administrative system to an address in the 192.168.0.0 network,
such as 192.168.0.200. The IP address must be different from that of the switch but within
the same subnet.
3. Click OK.
To configure a static address on the switch:
1. Use a straight-through cable to connect the Ethernet port on the administrative system
directly to any port on the GS716T and GS724T.
2. Open a Web browser on your PC and connect to the management interface as described in
Web Access on page 18.
3. Change the network settings on the switch to match those of your network (this procedure is
described in IP Configuration
After you change the network settings on the switch, return the network configuration on your
administrative system to the original settings.
on page 33).
Chapter 1: Getting Started | 17