NETGEAR GS716T Software Administration Manual page 42

To configure the Auto-DoS feature:
1. Select a radio button to enable or disable Auto-DoS:
• Disable. Auto-DoS is disabled (default).
• Enable. Auto-DoS is enabled.
2. Click Apply to send the updated configuration to the switch. Configuration changes occur
immediately.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
DoS Configuration
The DoS Configuration page lets you to select which types of DoS attacks for the switch to
monitor and block.
To access the DoS Configuration page, click System  Management  Denial of Service >
DoS Configuration.
To configure individual DoS settings:
1. Select the types of DoS attacks for the switch to monitor and block and configure any
associated values, as the following list describes.
• Denial of Service SIP=DIP. Enable or disable this option by selecting the appropriate
radio button. Enabling SIP=DIP DoS prevention causes the switch to drop packets
that have a source IP address equal to the destination IP address. The factory default
is Disable.
• Denial of Service First Fragment. Enable or disable this option by selecting the
appropriate radio button. Enabling First Fragment DoS prevention causes the switch
42 | Chapter 2: Configuring System Information
GS716Tv2 and GS724Tv3 Software Administration Manual