NETGEAR GS716T Software Administration Manual page 254

departments. Traffic from the Finance department is identified by each packet's network IP
address.
1. From the IP ACL screen, create a new IP ACL with an IP ACL ID of 1 (See
page 190).
2. From the IP Rules screen, create a rule for IP ACL 1 with the following settings:
• Rule ID: 1
• Action: Deny
• Assign Queue ID: 0 (optional: 0 is the default value)
• Match Every: False
• Source IP Address: 192.168.187.0
• Source IP Mask: 255.255.255.0
For additional information about IP ACL rules, see
3. Click Add.
4. From the IP Rules screen, create a second rule for IP ACL 1 with the following settings:
• Rule ID: 2
• Action: Permit
• Match Every: True
5. Click Add.
6. From the IP Binding Configuration page, assign ACL ID 1 to the interface gigabit ports 2, 3,
and 4, and assign a sequence number of 1 (See
By default, this IP ACL is bound on the inbound direction, so it examines traffic as it
enters the switch.
7. Click Apply.
8. Use the IP Binding Table screen to view the interfaces and IP ACL binding information (See
IP Binding Table
The IP ACL in this example matches all packets with the source IP address and subnet mask
of the Finance department's network and deny it on the Ethernet interfaces 2, 3, and 4 of the
switch. The second rule permits all non-Finance traffic on the ports. The second rule is
required because there is an explicit deny all rule as the lowest priority rule.
254 | Appendix B: Configuration Examples
GS716Tv2 and GS724Tv3 Software Administration Manual
on page 198).
IP Rules on page 191.
IP Binding Configuration
IP ACL on
on page 196).