NETGEAR GS716T Software Administration Manual page 182

To display the Protected Ports Membership page, click the Security  Traffic Control 
Protected Ports link.
To configure protected ports:
1. Click the orange bar to display the available ports.
2. Click the box below each port to configure as a protected port. Protected ports are marked
with an X. No traffic forwarding is possible between two protected ports.
3. Click Refresh to refresh the page with the most current data from the switch.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you make changes to the page, click Apply to apply the changes to the system.
Configuration changes take effect immediately.
182 | Chapter 5: Managing Device Security
GS716Tv2 and GS724Tv3 Software Administration Manual