NETGEAR GS716T Software Administration Manual page 155

GS716Tv2 and GS724Tv3 Software Administration Manual
To configure the RADIUS accounting server:
1. In the Accounting Server Address field, specify the IP address of the RADIUS
accounting server to add.
2. In the Port field, specify the UDP port number the server uses to verify the RADIUS
accounting server authentication. The valid range is 0–65535.
3. From the Secret Configured menu, select Yes to add a RADIUS secret in the next field.
You must select Yes before you can configure the RADIUS secret. After you add the
RADIUS accounting server, this field indicates whether the shared secret for this server has
been configured.
4. In the Secret field, type the shared secret to use with the specified accounting server.
5. From the Accounting Mode menu, enable or disable the RADIUS accounting mode.
6. Click Apply to update the switch with the RADIUS Accounting server settings.
7. To delete a configured RADIUS Accounting server, click Delete.
8. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Chapter 5: Managing Device Security | 155