NETGEAR GS716T Software Administration Manual page 45

GS716Tv2 and GS724Tv3 Software Administration Manual
To add a static entry to the local DNS table:
1. Specify the static host name to add. Enter up to 158 characters.
2. Specify the IP address in standard IPv4 dot notation to associate with the hostname.
3. Click Add. The entry appears in the list below.
4. To remove an entry from the static DNS table, select the check box next to the entry and
click Delete.
5. To change the hostname or IP address in an entry, select the check box next to the entry
and enter the new information in the appropriate field, and then click Apply.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
The Dynamic Host Configuration table shows host name-to-IP address entries that the switch
has learned. The following table describes the dynamic host fields:
Field
Host
Total
Elapsed
Type
Addresses
Click Refresh to refresh the table with the most current data from the switch.
Click Clear to delete Dynamic Host Entries. The table will be repopulated with entries as they
are learned.
Description
Lists the host name you assign to the specified IP address.
Amount of time since the dynamic entry was first added to the table.
Amount of time since the dynamic entry was last updated.
The type of the dynamic entry.
Lists the IP address associated with the host name.
Chapter 2: Configuring System Information | 45