System Board Shield - HP TouchSmart 9300 Elite Maintenance & Service Manual

9. Disconnect the cable from the board (2), and then remove the board from the computer.
NOTE:
pull on the wires.
Figure 7-50
To install the power button board, reverse the removal procedures.

System board shield

The system board shield sits above the system board. It is secured with three screws.
To remove the system board shield:
1. Prepare the computer for disassembly (see
2. Remove the stand (see
3. Remove the right and left rear panels (see
4. Remove the left cap (see
5. Remove the right cap (see
6. Remove the rear logo cover (see
7. Remove the rear main frame (see
8. Remove the three screws that secure the shield to the computer (1).
9. Disconnect the cable from the CONVER DB CONN system board connector (2).
76 Chapter 7 Removal and Replacement Procedures
Be careful not to damage the cable when disconnecting it from the connector. Do not
Removing the power button board
Stand on page
Left cap on page
Right cap on page
Preparing to disassemble the computer on page
34).
Rear panels on page
60).
66).
Rear logo cover on page
Main rear frame on page
46).
71).
74).
33).