Adjusting/Replacing Telescoping Front Rigging Support - Invacare Adjustable ASBA Service Manual

Adjusting/Replacing Telescoping Front Rigging Support

If the telescoping tubes need to be extended greater than two inches, then the seat
MUST be repositioned rearward to ensure stability - otherwise personal injury and/
or damage to the wheelchair and surrounding property may result.
NOTE: For this procedure, refer to FIGURE 6.5.
1. Remove the two cap screws, spacers and threaded blocks securing the telescoping
front tube to the side rail.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of six depth positions.
• Remove existing telescoping front rigging.
3. Secure the telescoping front tube to the side rail at the desired depth with the existing
two cap screws, spacers and threaded blocks.
4. Repeat STEPS 1 to 3 on the opposite side if desired.
NOTE: Sector style telescoping front tubes install the same way.
Side Rail
Cap Screws
FIGURE 6.5 Adjusting/Replacing Telescoping Front Rigging Support
Part No 1143238
WARNING
Side Rail
Spacers
27
SECTION 6—FRONT RIGGINGS
Spacers
Cap Screws
Threaded
Blocks
Telescoping
Front Tube
Adjustable ASBA Seat