Installing/Removing The Front Rigging/Eleveating Legrests; Raising/Lowering The Elevating Legrests - Invacare Veranda 3000 series User Manual

4.2 Installing/Removing the Front
Rigging/Eleveating Legrests
WARNING!
– After any adjustments, repair or service and before
use, make sure all attaching hardware is tightened
securely - otherwise injury or damage may occur.
Installing Front Riggings
Position the front rigging assembly A to the side of the
1.
wheelchair frame B.
Insert footrest mounting pin C into mounting tube D.
2.
3. Rotate the front rigging assembly towards the inside of the
wheelchair until it locks into place.
The footplate will be on the inside of the wheelchair
when locked in place.
4. Repeat this procedure for the other front rigging assembly.
A C
D
B
Front rigging shown. Elevating legrests install the same
way.
1567855-C
Removing the Front Riggings
1. Push or pull the front rigging release lever A to the side.
If desired, rotate front rigging assembly B outward or inward.
2.
Lift the front rigging assembly off of the mounting tube C.
3.
A
Front rigging shown. Elevating legrests Remove the same
way.
A

4.3 Raising/Lowering the Elevating Legrests

WARNING!
– Ensure hands and fingers are clear of elevating legrest
mechanism before pushing release lever to lower the
elevating legrest. Otherwise injury may occur due to
pinch points.
– The wheelchair user's leg MUST be supported by an
assistant before attempting to lower legrest.
B
Operation
A
23