Invacare Solara Service Manual page 28

SECTION 5—SEAT
After determining caster size and caster position needed, refer to Installing/Removing/
Adjusting Caster/Fork on page 44.
After determining rear wheel size, refer to the Owner's Manual, part number 1080556.
After changing Seat-to-Floor Height, the anti-tippers MUST be adjusted BEFORE
using the wheelchair. Refer to Installing/Adjusting Anti-tippers in the Owner's Man-
ual, part number 1080556.
FORK CASTER
6 inch/ 6 inch
Top Hole
NOTE: The seat-to-floor heights are based on pneumatic tires and pneumatic tires with flat free
inserts. If wheelchair is equipped with urethane tires, subtract ¼ inch from the measurements listed
above. All heights are measured with properly inflated new tires. These heights can vary ± ¼ inch
due to tire wear.
*NOTE: A 2-inch lower seat-to-floor is obtainable when attaching the seat pan/seating system to
the crossmembers instead of the seat rails.
™ ™
Solara and Solara Limited
WARNING
16 INCH SEAT-TO-FLOOR
REAR WHEEL AXLE PLATE
12 inch
28
SEAT-TO-FLOOR
Rounded Down/
Bottom 2 Holes
16 inch
*14 inch
Part No 1085787