Invacare Solara Service Manual page 38

SECTION 6—ARMS
NOTE: Make sure the two (2) extended ends of the spring are inside the notch in the locking lever.
6. Line up the mounting holes in the new locking lever, spring and bottom bracket.
WARNING
DO NOT over tighten the locknut that secures the locking lever to the bottom
bracket. Over tightening this locknut will prevent the locking lever from operating
properly, possibly causing injury.
7. Install mounting bolt and tighten securely with locknut.
8. Install the T-Arm onto the wheelchair. Refer to the Owner's Manual, part number
1080556.
Extended Ends
Spring
Bottom Bracket
Notch
Locknut
Mounting Bolt
Locking Lever
FIGURE 6.5 - REPLACING THE LOCKING LEVER - T-ARMS
™ ™ 38
Solara and Solara Limited Part No 1085787