Removing/Installing The Back Canes; Removing; Installing - Invacare Solara Service Manual

REMOVING/INSTALLING THE BACK CANES

BEFORE performing this procedure, refer to General Guidelines on page 13 for
additional requirements.
NOTE: Refer to FIGURE 7.4 for this procedure.

REMOVING

1. Remove the spreader bar from the wheelchair. Refer to Removing/Installing the
Spreader Bar on page 41.
2. Remove the mounting screw and locknut that secures the trigger release lever to the
back cane as shown in FIGURE 7.4.
3. Repeat STEP 2 for opposite side, if necessary.
4. Install the new back canes. Refer to Removing/Installing the Back Canes on page 43.

INSTALLING

1. Install existing mounting screw and locknut to secure the trigger release lever to the
new back cane.
2. Install the spreader bar onto the wheelchair. Refer to Removing/Installing the
Spreader Bar on page 41.
Back Cane
FIGURE 7.4 - REMOVING/INSTALLING THE BACK CANES
Part No 1085787
WARNING
Mounting
Screw
Trigger Release
Lever
Locknut
43
SECTION 7—BACK
™ ™
Solara and Solara Limited