Raising/Lowering Elevating Front Riggings; Adjusting/Replacing Telescoping Front Rigging Supports - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 10—FRONT RIGGINGS

Raising/Lowering Elevating Front Riggings

NOTE: For this procedure, refer to FIGURE 10.5.
1. Perform one of the following:
A. Raising - Pull back on the release lever and raise front rigging to the desired height.
B. Lowering - Support front rigging with one hand away from the release lever and
push release lever downward with other hand.
FIGURE 10.5 Raising/Lowering Elevating Front Riggings
Adjusting/Replacing Telescoping Front Rigging
Supports
NOTE: For this procedure, refer to FIGURE 10.6 on page 63.
When determining the depth of the telescoping front rigging tubes, make sure the
rear of the footrests do not interfere with the movement of the front casters.
Otherwise damage to the wheelchair may result or may impede proper operation.
NOTE: Telescoping front rigging supports may be extended up to 2-inches from the wheelchair
frame in 1-inch increments. This adjustment does not affect seat depth.
NOTE: When installing the front rigging support tubes, ensure that the hinge pins are on the
outside of the chair facing away from the seat frame.
NOTE: The two telescoping front rigging supports can be positioned at different depths.
1. Remove the two mounting bolts and spacers that secure the telescoping front rigging
support to the seat frame.
2. Remove the end cap.
3. Perform one of the following:
• To adjust - slide the existing telescoping front rigging support to one of three depth
positions.
• To replace - remove the existing telescoping front rigging support.
® ™
Pronto M71 Jr. with SureStep
WARNING
® 62
Release
Lever
Part No 1122147