SECTION 6—ARMS
90°
Back Angle Adjustment
110°
Back Angle Adjustment
Arm Adjustment Plate
FIGURE 6.3 - ADJUSTING CANTILEVER ARM ANGLE
INSTALLING T-ARM SOCKETS
NOTE: Refer to FIGURE 6.4 for this procedure.
1. Remove rear wheels from wheelchair, if necessary, refer to the Owner's Manual, part
number 1080556.
2. Position the T-Arm clamp on the wheelchair frame as shown in FIGURE 6.4.
NOTE: The T-Arm socket must be positioned on the outside of the wheelchair frame.
3. Install hex bolts through T-Arm clamp, wheelchair frame and coved washers and
tighten securely with locknuts.
4. Position the T-Arm socket inserts in the T-Arm socket as shown in FIGURE 6.4.
™
™
Solara
and Solara
Limited
Arm
Adjustment
Plate
Arm
Adjustment
Plate
Locking Pin
Washer
100°
Back Angle Adjustment
120°
Back Angle Adjustment
Locknut
36
Arm
Adjustment
Plate
Arm
Adjustment
Plate
Part No 1085787