Section 11-Assembly; Assembling The Solara Wheelchair - Invacare Solara Service Manual

Hide thumbs Also See for Solara:

Table of Contents

SECTION 4—ASSEMBLY

BEFORE performing this procedure, refer to General Guidelines on page 13 for

additional requirements.

After ANY adjustments, repair or service and BEFORE use, make sure that all

attaching hardware is tightened securely - otherwise injury or damage may result.

NOTE: Refer to FIGURE 4.1 for this procedure.

1. Unpack the contents of the Solara wheelchair shipping carton.

2. Unfold the back. Refer to Folding/Unfolding Back Assembly in the Owner's Manual,

part number 1080556.

3. Install the rear wheels. Refer to Installing/Removing Rear Wheels in the Owner's

Manual, part number 1080556.

4. Install the front caster/fork assemblies. Refer to Installing/Removing/Adjusting

Caster/Fork on page 44.

5. Install the front riggings or contracture assembly. Refer to Front Riggings or

Contracture Footplate Option in the Owner's Manual, part number 1080556.

6. If necessary, install the wheel locks. Refer to Removing/Installing Wheel Locks on

page 50.

7. Install the anti-tippers. Refer to Installing/Adjusting Anti-tippers in the Owner's

Manual, part number 1080556.

8. If necessary, adjust the back angle. Refer to Adjusting Back Angle on page 40.

9. If necessary, reposition the rear wheels.Refer to Repositioning Axle Plate on page 48.

™

Solara

and Solara

Limited

WARNING

Part No 1085787

Table of Contents

Solara limited