Replacing/Repositioning Cantilever Arm Locking Lever - Invacare Solara Service Manual

SECTION 6—ARMS
2. Remove the locknut that secures the front arm socket to the wheelchair frame.
3. Remove existing front arm socket from the wheelchair.
4. Install the new front arm socket into the wheelchair frame.
5. Securely tighten the new front arm socket to the wheelchair frame with the existing
locknut.
6. Repeat STEPS 2-5 for opposite side, if necessary.
7. Do one (1) of the following:
A. Seat Pan - Install the seat pan onto the wheelchair. Refer to Removing/Installing
Seat Pan on page 22.
B. Seating System - Install the seating system onto the wheelchair. Refer to the Seating
Systems Owner's Manual for installing/removing procedures.
NOTE: Seat positioning strap NOT shown for clarity.
FIGURE 6.1 - REMOVING/INSTALLING DUAL POINT ARM SOCKETS
REPLACING/REPOSITIONING CANTILEVER
ARM LOCKING LEVER
The locking mechanism is spring loaded. Place your free hand over the locking
mechanism to prevent the parts from springing out of the cantilever arm.
NOTE: Refer to FIGURE 6.2 for this procedure.
1. Flip the cantilever arm up and out of the way.
2. Unscrew the actuator from the locking mechanism.
3. Remove the locking mechanism and spring from the cantilever arm.
™ ™
Solara and Solara Limited
Coved Washers
Locknuts
Wheelchair Frame
Locknut
CAUTION
FRONT Arm Socket
34
Back Plate
REAR Arm Socket
Hex Screws
Part No 1085787