Installing Trigger Release With Cable; Removing/Installing Tilt Slide; Removing Tilt Slide; Installing Tilt Slide - Invacare Solara Service Manual

SECTION 9—TILT-IN-SPACE

INSTALLING TRIGGER RELEASE WITH CABLE

1. Secure the new trigger release lever to the back cane with the existing mounting screw
and locknut.
2. Secure the cable to the bearing housing with the existing two (2) allen screws and
washers.
NOTE: Make sure the cable sits flush against the bearing housing.
3. Secure the cable to the wheelchair frame with tie wrap.
4. Adjust the trigger release cable(s). Refer to Adjusting Trigger Release Cables in the
Owner's Manual, part number 1080556.

REMOVING/INSTALLING TILT SLIDE

NOTE: Refer to FIGURE 9.2 for this procedure.

REMOVING TILT SLIDE

1. If necessary, remove the seating system from the wheelchair. Refer to the seating
systems Owner's Manual for installing/removing procedures.
2. Remove the shoulder screw and locknut that secure the bearing housing to the seat
frame (Detail "A").
3. Remove the two (2) allen screws and locknuts that secure the existing tilt slide to the
wheelchair frame (Detail "B").
4. Note the position of the tilt locking collars on the existing tilt slide.
5. Remove the four (4) allen screws that secure the two (2) tilt locking collars to the
existing tilt slide.
6. Remove the tilt locking collars from the existing tilt slide.
7. Remove existing tilt slide and bearing housing from the tilt slide housings.
8. Repeat STEPS 2-7 for opposite side, if necessary.
9. Install the new tilt slide onto the wheelchair. Refer to Installing Tilt Slide on page 52.

INSTALLING TILT SLIDE

1. Install the new tilt slide and existing bearing housing into the tilt slide housings.
2. Secure tilt slide and tilt slide housings to the wheelchair frame with the two (2) allen
screws and locknuts.
3. Secure the bearing housing to the seat frame with the shoulder screw and locknut.
4. Install the tilt locking collars at the position noted in STEP 4 of Removing tilt Slide on
page 52.
NOTE: To change position of tilt locking collars, refer to Positioning Tilt Locking Collars in the
Owner's Manual, part number 1080556.
™ ™
Solara and Solara Limited
52
Part No 1085787