Raising/Lowering Elevating Front Riggings; Adjusting/Replacing Telescoping Front Rigging Support - Invacare Formula Powered Seating Owner's Operator And Maintenance Manual

Table of Contents

SECTION 6—FRONT RIGGINGS

NOTE: Make sure spacers are positioned properly when reassembling to prevent damage to the

frame mounting tubes.

6. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Footrests on

page 35.

7. Reinstall any accessory onto the footrest(s).

Raising/Lowering Elevating Front Riggings

NOTE: For this procedure, refer to FIGURE 6.6.

1. Perform one of the following:

• Raising - Pull back on the release

lever and raise front rigging to the

desired height.

• Lowering - Support front rigging

with one hand away from the

release lever. Push release lever

downward with other hand.

If the telescoping tubes need to be extended greater than two inches, then the seat

must be repositioned rearward to ensure stability - otherwise personal injury and/or

damage to the wheelchair and surrounding property may result.

NOTE: For this procedure, refer to FIGURE 6.7 on page 39.

1. Remove the two cap screws, spacers and threaded blocks securing the telescoping

front tube to the side rail.

2. Perform one of the following:

• Slide existing telescoping front rigging support to one of six depth positions.

• Remove existing telescoping front rigging.

3. Secure the telescoping front tube to the side rail at the desired depth with the existing

two cap screws, spacers and threaded blocks.

4. Repeat STEPS 1 to 3 on the opposite side, if desired.

Formula™ Powered Seating

All manuals and user guides at all-guides.com

WARNING

FIGURE 6.6 Raising/Lowering Elevating

Front Riggings

Release

Lever

Part No 1122170

Table of Contents