Table of Contents
Advertisement
5.
Slide the M12-1.75 T-nut into the sliding table
and thread in the M12-1.75 x 12 push handle
with a washer as shown in Figure 42.
Push
Handle
Figure 42. Sliding table push handle.
6.
Slide the edge shoe into the table as shown
in Figure 43 when needed.
Edge
Shoe
Figure 43. Edge shoe and hold down placement.
7.
Slide the hold down onto the table when
needed and lock it in place as shown in
Figure 43.
G0451 14" Sliding Table Saw
The Model G0451 is designed to accommodate
either a 12" or a 14" main blade. But any time
you change blade sizes, the riving knife must be
adjusted to match the size of blade you install.
Components and Hardware Needed:
Blade 12" or 14" (Not Included) .........................1
Flat Belt 15 x 915mm .........................................1
Riving Knife ........................................................1
Tools Needed:
Arbor Wrenches .................................................2
To install the blade:
1.
Open the motor compartment and
the red shipping brackets from both motors.
2.
Place the flat belt on the scoring blade arbor
as shown in Figure 44, lift the scoring motor,
and slide the flat belt over the scoring motor
pulley.
Scoring
Blade
Arbor
Hold
Down
3.
Move the blade tilt to 0˚ and raise the main
blade as far as it will go.
Main Blade
Figure 44. Flat belt installation.
Qty
remove
Flat
Belt
Scoring
Motor
-29-
Advertisement
Table of Contents
