Scale - Grizzly G0451 Instruction Manual

6.
Check the surfaces of the table with a
straightedge as shown in Figure 23.
Figure 23. Checking with a straightedge.
7.
Use the set screws under both extension
tables to level the top surfaces with the saw
table.
8. When the surfaces are level, thread the bolt
shown in Figure 24 against the underside
of the small extension table to hold it level.
Figure 24. Small extension table support bolt.
9.
Tighten all of the cap screws securing the
tables.
G0451 14" Sliding Table Saw

Scale

Components and Hardware Needed:
Rip Fence Scale ................................................ 1
Cap Screws M10-1.5 x 20 ..................................4
Hex Nuts M10-1.5 ..............................................2
Lock Washers 10mm ..........................................4
Flat Washers 10mm ...........................................4
Tools Needed:
Hex Wrench 8mm ...............................................1
Socket or Wrench 16mm ....................................1
To install the scale:
1. Loosely thread four M10-1.5 x 20 cap screws
with lock and flat washers through the scale
and into the table as shown in Figure 25.
Figure 25. Attaching the scale.
2.
Secure the cap screws to the extension
table with M10-1.5 hex nuts, but do not fully
tighten.
3. Line the scale up with the top of the table and
tighten the cap screws.
Qty
Qty
-23-