Miter Cutting - Grizzly G0451 Instruction Manual

Miter Cutting

The miter fence allows miter cuts from 0˚ through
135˚. The table mounted miter scale has a resolu-
tion of 1˚.
To perform a miter cut:
1. Slide the crosscut table to the front edge of
the sliding table and lock it in place.
2. Place the crosscut fence center stud in the
center stud hole of the crosscut table. The
fence can be installed as shown in Figure 73
for 90˚ to 135˚ cuts, or as shown in Figure 74
for 0˚ to 90˚ cuts.
Figure 73. Fence set-up for 90˚ to 135˚ cuts.
-42-
3.
Rotate the fence to the desired angle and
use the lock knob to lock the fence in place.
4.
Position the flip stop according to the length
of the workpiece you want to cut off to the left
of the blade.
5. Load the workpiece onto the table saw. The
set up should look similar to Figure 74.
Figure 74. Example of miter cutting operation.
6.
Once all the necessary safety precautions
have been taken, perform the cutting opera-
tion.
G0451 14" Sliding Table Saw