Crosscut Fence - Grizzly G0451 Instruction Manual

Crosscut Fence

Components and Hardware Needed:
Crosscut Fence ..................................................1
Center Stud M8-1.25 x 10 ..................................1
Fiber Washer 8mm .............................................1
T-Nut M8-1.25 .....................................................1
Knob M8-1.25 x 25 .............................................1
Knob M8-1.25 .....................................................1
T-Bolt M8-1.25 x 60 ............................................1
Flat Washer 8mm ...............................................1
Tools Needed:
Hex Wrench 6mm ...............................................1
To install the crosscut fence:
1.
Thread the center stud and the fiber washer
into the remaining M8-1.25 T-nut.
2. Slide the center stud, an M8-1.25 x 60 T-
bolt, and screw a M8-1.25 x 25 knob into the
crosscut fence as shown in Figure 36.
Center Stud
Figure 36. Crosscut fence assembly.
3. Slide the center stud to the end with the plas-
tic cap and tighten it in place.
G0451 14" Sliding Table Saw
Qty
Qty
Knob
T-Bolt
4.
Insert the center stud and the T-bolt in the
places indicated in Figure 37.
Center Stud
Placement
Figure 37. Crosscut fence placement.
5. Secure the crosscut fence with the M8-1.25
knob with an 8mm flat washer threaded onto
the T-bolt.
6. Unlock the crosscut fence extension and
slide the flip stops into the fence as shown in
Figure 38.
Figure 38. Stop block installation.
T-Bolt
Placement
-27-