Table of Contents
Advertisement
Aligning Scoring
Blade Set
To align the scoring blade set:
1.
Move the blade tilt to 0˚ (blade 90˚ to table),
raise the main blade all the way up, and use
the vertical adjustment knob (Figure 49) to
raise the scoring blade to its highest point.
Scoring
Blade Vertical
Adjustment
Scoring Blade
Horizontal
Adjustment
Figure 49. Scoring blade adjustment controls.
2.
Move the rip fence against the main blade (or
scoring blade) as shown in Figure 50.
Figure 50. Fence used to align blades.
3.
Use the horizontal adjustment controls to
adjust the scoring blade until the rip fence
can touch both blades.
G0451 14" Sliding Table Saw
Adjusting Scoring
Blade Kerf
The kerf of the tapered scoring blade included
with this sliding table saw is adjusted by changing
the height of the scoring blade. See Page 37 for
replacement scoring blade adjusting instructions.
To change the scoring blade kerf:
1.
Measure the main blade kerf, then measure
the scoring blade kerf at the table level.
2.
Raise or lower the scoring blade until the kerf
matches the kerf of the main blade.
3.
Perform a test cut and check for chip out on
the underside of the test piece. If there is
chip out, make the adjustments necessary to
match the kerfs.
Scale Alignment
Before operation, align the rip fence scale with
the blade to ensure accurate measurements.
Tools Needed:
Hex Wrench 3mm ...............................................1
Hex Wrench 8mm ...............................................1
To align the fence scale with the blade:
1.
Tilt the blade to 0˚, raise the main blade all
the way up, and move the rip fence against
the blade as shown in Figure 50.
2.
Loosen the screws securing the scale, line up
the first mark on the scale with the left edge
of the rip fence, then tighten the screws.
3.
Set the rip fence to
ring against the fence, and secure the ring to
prevent the fence from contacting the blade.
QTY
⁄
", slide the adjustable
1
8
-31-
Advertisement
Table of Contents
