Extension Tables - Grizzly G0451 Instruction Manual

Extension Tables

Components and Hardware Needed:
Large Extension Table .......................................1
Small Extension Table ........................................1
Support Brace ....................................................1
Dust Collection Hose Support ............................1
Cap Screws M10-1.5 x 30 ..................................4
Cap Screws M10-1.5 x 20 ..................................6
Hex Nuts M10-1.5 ..............................................2
Lock Washers 10mm ........................................ 10
Flat Washers 10mm ...........................................6
Set Screws M6-1 x 12 ........................................6
Tools Needed:
An Assistant .......................................................1
Hex Wrench 3mm ...............................................1
Hex Wrench 8mm ...............................................1
Socket or Wrench 16mm ....................................1
Straightedge 4' (or longer) ..................................1
To install the extension tables:
1.
Thread the set screws into the small holes
in both extension tables. Make sure the set
screws do not stick out from the mating sur-
face.
Note—Do not completely tighten the bolts in the
following steps until the tables are leveled.
2. Attach the small extension table with two
M10-1.5 x 20 cap screws, lock washers,
and flat washers as shown in Figure 20.
Note—Get assistance positioning the tables
and holding them in place while installing.
Figure 20. Small extension table attachment.
-22-
3.
Attach the large extension table with four
M10-1.5 x 20 cap screws, lock washers, and
flat washers as shown in Figure 21.
Qty
Qty
Figure 21. Large extension table attachment.
4. Attach the support brace (Figure 22) to the
table with two M10-1.5 x 30 cap screws and
lock washers. Note—Do not attach the brace
to the extension table until the next step.
Figure 22. Support brace and dust collection
5. Place the dust collection hose support over
the support brace as shown in Figure 22
and thread M10-1.5 x 30 cap screws with
lock washers through the remaining support
brace holes and secure with hex nuts.
Dust Collection
Hose Support
Support Brace
hose support installation.
G0451 14" Sliding Table Saw