Table of Contents
Advertisement
10. Repeat Steps 4-9 until the gap between the
blade and the sliding table is equal.
11. Tighten the jam nuts on the parallel adjust-
ment bolts to secure them in place
12. Tighten the table mounting bolts and replace
the access plates.
Squaring Crosscut
Fence to Blade
Squaring the crosscut fence to the blade ensures
that cuts made with the crosscut fence will be
square. This procedure can be done by using
a piece of scrap plywood as a test piece and
making five test cuts, then adjusting the fence as
necessary.
To square the crosscut fence with the blade:
1.
Make sure the blade is parallel with the slid-
ing table.
2.
Prepare the scrap test piece by cutting it to
32" x 32" and number all four sides of the test
piece.
-52-
3.
Use the crosscut fence to cut
side of the test piece, then cut side 1 again
(make five cuts total).
4.
Measure the test piece diagonally from cor-
ner-to-corner as shown in Figure 96.
— If both measurements are not within
then the crosscut fence needs to be
adjusted. Proceed to Step 6.
— If both measurements are within
you are finished with this procedure.
Figure 96. Fence adjustment test piece.
5.
Loosen the set screw shown in Figure 97
and rotate the cam to square the crosscut
fence.
Figure 97. Crosscut fence adjustment cam.
6.
Tighten the set screw and repeat Step 3-6.
G0451 14" Sliding Table Saw
⁄
" off of each
1
2
⁄
",
1
16
⁄
" then
1
16
Advertisement
Table of Contents
